Discuss Help please Baxi 105e instant in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
J

jezhawk

Hi everyone this is my first post here
i need some help if anyone can offer any.

I have a baxi 105e instant i get hot water upstairs but not in the kitchen downstairs,if i put the tap on upstairs (Hot) then it will through hot downstairs.

Also the hot used to be hot in 3-5 seconds but now it takes 30 + seconds to get hot i dont know if this might be causeing the problem downstairs ....other than that the boiler works as it should

i hope someone can help thanks in advance if you can
 
Hi forgot to mention that a plumber told me it might be the tap so i just bought a new mixer tap and its the same :(( still no water oly when i turn it on upstairs
 
Replace hot water diaphragm in boiler ,probably stretched,flow rate maybe lower on kitchen tap

imho
 
well tbh cant see how you can have a boiler fault if one outlet works but not the other strange:confused:

Replace hot water diaphragm in boiler ,probably stretched,flow rate maybe lower on kitchen tap

imho

its the instant puddle,has no diaphragm but it may have a snapped differential pressure rod but this would normally cause it to scream its head off and no hot water anywhere
 
Last edited by a moderator:
Hi everyone this is my first post here
i need some help if anyone can offer any.

I have a baxi 105e instant i get hot water upstairs but not in the kitchen downstairs,if i put the tap on upstairs (Hot) then it will through hot downstairs.

Also the hot used to be hot in 3-5 seconds but now it takes 30 + seconds to get hot i dont know if this might be causeing the problem downstairs ....other than that the boiler works as it should

i hope someone can help thanks in advance if you can
had similar problem with a worcs grn star jnr it was a problem with the kitchen sink taps not being able to pass enough water , are they regstrictive taps , do you get a good flow rate through problem taps, try to run off some water before it goes to tap ie. put temp flexible tap connector hose underneath sink , if it stays hot then change taps or repair them if your feeling lucky .

well tbh cant see how you can have a boiler fault if one outlet works but not the other strange:confused:



its the instant puddle,has no diaphragm but it may have a snapped differential pressure rod but this would normally cause it to scream its head off and no hot water anywhere
swear the boilers got a diaphragm cos it pushes spindle out to make a microswitch attatched to housing , we are talking about the first 105 e and not the he model i take it
 
Last edited by a moderator:
yes i get a good flow and ive spent 3 hours today changing tap for a new one,but find it strange that it wont let hot threw unless i turn upstairs tap on to hot first.
And there is no noise from the boiler like i said all seems normal except its not istant hot water like it used to be takes a little while now before gets hot.
 
had similar problem with a worcs grn star jnr it was a problem with the kitchen sink taps not being able to pass enough water , are they regstrictive taps , do you get a good flow rate through problem taps, try to run off some water before it goes to tap ie. put temp flexible tap connector hose underneath sink , if it stays hot then change taps or repair them if your feeling lucky .


swear the boilers got a diaphragm cos it pushes spindle out to make a microswitch attatched to housing , we are talking about the first 105 e and not the he model i take it

its not a 105e its a 105 instant very different macine

to the op, the last poster has a point is it a 105e or 105 instant? it cant be both,and appoligies to puddle if its not a instant
 
Last edited by a moderator:
Well just checked the front it says BAXI Combi instant 105e

sn# MBH0421
thats it
 
right its the instant confusing:confused:perhaps thats what the early ones were called it does have a small diaphram on the dhw but its not likely to cause this fault does it whine at all when you pull hot water off it? if so it could be the differential dhw pressure valve baxi sometimes refer to this as a sheil valve,what can cause confusion is there are two baxi 105 boilers the 105 e and 105 instant the 105e is regarded by many as the best combi ever made were as the 105 instant sadly is A unreliable peice of tat sorry if you have THAT version
 
Last edited by a moderator:
Status
Not open for further replies.

Reply to Help please Baxi 105e instant in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Replies
2
Views
227
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
227
S
Hi, I seemed to have a blockage in kitchen sink. A plumber came and cleared all the pipework that is visible inside my home (there was debris and...
Replies
2
Views
163
Sonya K
S
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4...
Replies
9
Views
465
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock