Search the forum,

Discuss Shower mixer problem in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
S

Soumen

Hello all,

I need advice on a bath tap/shower mixer unit. I have recently moved into a flat where the bathroom comes with a tap/shower mixer unit which has a "diverter" consisting of a button which you pull up to divert the water up through a flexible 'metal' pipe and the attached shower head instead of through the bath taps. When the button is down, both hot and cold water can be regulated through the spout, and the water pressure and temperature changes proportionately to the amount which either the hot or cold water tap is turned. So with both hot and cold on full, the flow is very good and the temperature is luke warm to cool - this is all fine.
The problem occurs the moment I pull up the diverter to switch on the shower. The water flow seems to reduce and the shower water temperature rises. I then tried just using hot water through the shower and that works fine (good pressure) - but the moment I switch on the cold water tap - the shower pressure decreases significantly but the temperature of the water seems to remain just as hot. So basically while the hot water is running via the diverter through the shower, upon also switching on the cold water creates only a reduction of shower water pressure but the water temperature remain just as hot.
Can someone please help diagnose the problem and recommend a solution?

Thanks,

Soumen
 
Not really sure what the problem is. :confused:

I take it you have a combi boiler?

If so it is normal for the hot flow to decrease slightly when the cold tap is turned on.
 
Sorry Phil and thanks for your prompt reply. The problem is that with the diverter on and hot water only on, the moment I switch on the cold water, the water pressure drops about 50%, (instead of increasing due to the new flow of cold water), but the water remains hot (so the cold water does not seem to come through). For reference, if the diverter was off (i.e water through the spout), then there is no problem. And, 'yes', there is a combi-boiler but the problem I described above only occurs for the shower (not the tub spout or sinks).
 
Status
Not open for further replies.

Reply to Shower mixer problem in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
122
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
131
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
324
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock