Search the forum,
Questions and plumbing advice in the Water Underfloor Heating Advice - .

Some popular plumbing forums: Plumbing Advice - Plumbing Tools - Plumbing Courses & NVQ's

Forum Prefix Filter

Water UFH Installers Directory

Water Underfloor Heating Installers Directory. Here we help you find professional expert water underfloor heating installers in our free to use directory. Always use this forum as part of your own research. We can surely find you a water UFH installer with lots of references to check etc. :)
Threads
2
Messages
13
Views
6.8K
Threads
2
Messages
13
Views
6.8K
Hi all. If I may, I'd like to ask some beginner's questions. The situation: We think we may have air trapped in our UFH system. Therefore, we're considering refilling the circuits. However, there are a few details we need to clear up first. First of all, we need (?) to buy some hose end...
Replies
0
Views
698
  • Question
Hi I have a Pulsar underfloor heating manifold with a leaky thermostatic valve. Plumber has managed to stop leak by tightening nut but this is 2nd time it’s leaked through ceiling in few months so was hoping to renew. However plumber been unable source a replacement/ equivalent as I know Pulsar...
Replies
0
Views
441
Hi guys - hoping someone can help... Have a 12 yr old Wunda 2-zone wet underfloor heating system which is starting to fail (zone heating up despite stat being off) and a generally old and inefficient thermostat system. Difficult currently to get anyone to come have a look at it, managed to get...
Replies
0
Views
816
T
This morning I heard knocking coming from my bathroom sink drain! The central heat outdoor unit is just outside the wall, and it was running. I went outside, but it seemed fine. When the heat unit went off, the knocking stopped. What the hey? I have a video, but I didn't see a way to add it to...
Replies
0
Views
507
Tom in Texas
T
We have a Daikin Air Source heat pump feeding our hot water and under-floor 8 port manifold heating system. The Daikin has just had its annual service and the engineer commented that the water looked discoloured and that the inhibitor needed replacing?? Is this an easy procedure? I'm pretty...
Replies
0
Views
344
Our pulsar infloor was installed in 2006 and worked well until a total heating failure in 2020. Following its repair and a new bolier the infloor has not worked properly. Several different plumbers have attended but still no improvement .Are there pulsar specialists out there in the plumbing world?
Replies
0
Views
926
I have a client with 5 manifolds that are Pulsar Direct supplied .I know Pulsar direct are no longer. I have a few with leaking TRV (RBM -TL50) pins. How easy is it to change the pin side of the valve. . Are they standard or specific to the manifold? Where would I look for spares. Just had 'we...
Replies
0
Views
1K
Hello, I am new here and have come looking for help. I live a small 2 floor ( 1 bedroom house) with Polypipe underfloor heating. the UFH is upstairs and downstairs. Its been installed for around 6 years and worked fine, I have 2 single RF receivers under the stairs ( this is it Polypipe RF...
Replies
0
Views
2K
A
Any luck on the rifeng flow meters . I’m looking for two fine thread too !
Replies
0
Views
817
Amanda A
A
Post a New Thread / Question
Creating content since 2001. Untold Media.
OFFICIAL SPONSORS

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock