Search the forum,

Discuss Usage of non-barrier PEX in section of radiant underfloor heating system in the Plumbing Jobs | The Job-board area at PlumbersForums.net

P

plumb-paddy

Hi all.

I have an oil powered underfloor heating system in my house. When the house was plumbed I requested that all of the PEX pipes of the underfloor heating and in the district heating pipe from the boiler in the garage be PEX pipes with an oxygen barrier to minimise the risk of oxygen diffusion occurring in the system.

I have discovered that 3/4 inch PEX WITHOUT a barrier was used to get the water to and from the underfloor heating manifold on the first floor of the house. All other PEX pipes in the underfloor system and to the boiler that feeds the underfloor system are PEX with a barrier or copper. There is about 40 feet in total of this non-barrier PEX in the supply and return to the manifold.

My question is could the 40 foot section of non-barrier PEX used to link to the manifold cause oxygen to accumulate in the rest of the system and impact on the lifetime of the ferrous components and possibly even impact on the life of the other PEX pipes in the system or am I being a little over cautious here?

Thanks,
Paddy.
 

Reply to Usage of non-barrier PEX in section of radiant underfloor heating system in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
2
Views
203
P
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
139
Just started gound work on self build bungalow and wondering best way to do below ground soil pipes. For toilet I was going to go straight down through slab and out through deadwork into a manhole. I will work out falls from manhole and set the height of the waste water system as required. For...
Replies
2
Views
115
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
189
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
245
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock