Discuss Shower/mixer tap - slow flow in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
J

jhatter

Hi,

I have a a shower/mier tap set which I bought from Homebase and had fitted by a plumber about 2 years ago ([DLMURL="http://www.homebase.co.uk/webapp/wcs/stores/servlet/Browse?storeId=20001&langId=-1&c_1=1%7Ccategory_root%7CBathroom%7C9576969&c_2=2|cat_9576969|Bathroom+taps+and+mixers|9579980"]Chrome Victorian Bath/Shower Mixer [/DLMURL]> on their website).

The hot water tap is running very slowly, almost a dribble. Other hot taps in my house are running OK, so I assume it is the tap and not the boiler pressure.

I think the problem is with the washer (?) can someone please verify this and explain how to change a washer.

Thanks
 
Last edited by a moderator:
isolate the water
remove the white centre cap on tap
under that willbe a crosshead screw which then removes the crosshead handl.
remove the chrome shroud.then with a adjustable spanner you can remove the brass insert to which the tap washer is attatched.
 
Thanks for your reply.

I can complete the first 3 steps - not sure about step 4.
"...then with a adjustable spanner you can remove the brass insert to which the tap washer is attatched".....

The brass insert only twists back and forth as much as the tap would turn originally and then stops. Do I have to apply a lot of pressure to turn and remove it completely with the spanner? It has fine grooves all around it which are in danger of being damaged if I squeeze too tightly with the spanner.

Thanks for your patience, but you are dealing with a keen novice. I look forward to your reply.
 
there should be a hexagon on the insert that you put your adjustable spanner on without damaging the shroud thread.
 
Please could you look at the 2 pics I took, if you have the time and advise me from there.

Thanks

[DLMURL="http://www.users.waitrose.com/~johnhathway/taps.htm"]John Hathway[/DLMURL]

just to let you know the link can be seen by clicking my name in the previous post!
 
Last edited by a moderator:
pic 2 the chrome shroud needs to come off. they can be a bugger to free and be careful as you can damage them or crush them.
 
Status
Not open for further replies.

Reply to Shower/mixer tap - slow flow in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Looking for any ideas to help. I've a Heatrae Sadia Hot Water tank, heated through Oil fired boiler (working fine). A week ago I reset the air...
Replies
8
Views
346
I have just replaced the old bathroom basin mono mixer taps, 2 tap heads, standard compression valve type, to a modern mono mixer single lever...
Replies
30
Views
3K
    • Like
Hoping someone can please help. I have an intermittent fault with my electric hot water. I have an older style electric hot water service that...
Replies
6
Views
479
M
Hi, My gravity fed hot water slows to nothing over 30 seconds. when tap turned off for 5 mins, tap will run again for 30 seconds etc. I have...
Replies
2
Views
412
Hi, I hope someone can help. I’m hoping this isn’t a permanent problem. We’ve converted a gravity vented hot water system, into an unvented...
Replies
18
Views
1K
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock