Discuss Pipe bending in the Plumbing Jobs | The Job-board area at PlumbersForums.net
i have seen places where you can buy the crossover bends ready to go,but not sure if it would be worth it in the real world??
just buy the end feed ones quicker and tighter than you can get with a bender and if you have to do several on show perfect every timeAre there any 'tricks of the trade' that someone could kindly pass on with regards to bending passover bends as i'm finding them a right pain to master......
just buy the end feed ones quicker and tighter than you can get with a bender and if you have to do several on show perfect every time
A pipe bender is not the "be all and end all", bending springs can get you out of trouble as well, a "rolling offset pass-over" is one that cannot be easily done with a machine, if at all
Once I had to cross the pipe work, only 3/4" copper, the other plumber had connected the hot to the w/c and bath & basin were also connected hot to cold, in the master bed room en suite bath room, it was tight for space to do this because the finished floor was down in the bath room, could not chop the joists lower, to use fittings for a passover, so I pulled two sets of off-sets to mate up to the distance between the pipes, and then pulled a slight passover in both of the offsets, so that one would dip a bit and the other would rise a bit where the pipes crossed each other
Reply to Pipe bending in the Plumbing Jobs | The Job-board area at PlumbersForums.net
We get it, advertisements are annoying!
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.