Search the forum,

Discuss Faulty shower mixer in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
C

Connor Williams

Hello all,

I have a wall mounted shower mixer that will no longer shut off,the water dribbles through the shower head and I can hear the mains water seeping through.
This mixer is difficult to strip down and the water in the area is very hard, should I replace the mixer or can they be straightforward to rewasher/repair?
Many thanks for any help.

All the best,
Connor
 
Hello all,

I have a wall mounted shower mixer that will no longer shut off,the water dribbles through the shower head and I can hear the mains water seeping through.
This mixer is difficult to strip down and the water in the area is very hard, should I replace the mixer or can they be straightforward to rewasher/repair?
Many thanks for any help.

All the best,
Connor
realy depends on the make trevi aqualisa mira id repair most everything else id change
 
sirrus? or what
you can get a new cartridge as the seal has gone inside it may only need a new 'o' ring therefore get a service kit.
 
Status
Not open for further replies.

Reply to Faulty shower mixer in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
119
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
244
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
227
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
187
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
232
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock