Discuss Drayton Digistat+ 3 hard wire problem in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Yeah the Honeywell worked fine I only replaced it caused it looked dated. The temperature in the house ATM is 25 degree centigrade I override it to 30 the small flame appeared on the display and it should then fire the boiler up? I did read this programmer and all other thermostatic programmers that are made now have an intelligents built into it. I'm thinking because I
The house is already very warm it won't fire the boiler due to the fact that it's too warm and this must be the intelligents kicking which makes it be energy effiencency? Would I be correct?
What if I swap wires around?
What is the worst it can do if it doesn't work? Could it blow the fuse?
Should it matter if the red sleeving is biting down on the screw rather than the copper wire in the connecter block on the Drayton programmer?
Yeah shaun I've done it that way. From your experience What could be the problem?
Yeah the old stat worked fine no problems. The battery's from the Drayton are roasting hot?
No I turned the power off from the consumer unit.
I bought it yesterday from bnq
Ok. What type of programmer thermostat would you recommend ?
Thank for all your help.
Combi boiler.
Got it working. The face on the programmer wasn't connecting the pcb board. As I had it screw too tight against the wall. It's clicking off and off now. Great.
Yeah I know. When I remove the back case and put the front back on I heard the signal wire making a click sound to the boiler then it fired up. Thanks to your patience and expert advise now I have a new programmer working.
Thanks again.
Reply to Drayton Digistat+ 3 hard wire problem in the Plumbing Jobs | The Job-board area at PlumbersForums.net
We get it, advertisements are annoying!
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.