Search the forum,

Powe Flushing Question

Post new thread

Discuss Powe Flushing Question in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
S

Smeagal

Hi Everyone


Can anybody tell me if when you flush an open vented System fitted with a Primatic,after you have drained down and removed the cylinder and capped the pipes can you then directly refill the system from the powerflushing unit and bleed the rads in preparation to start flushing.Power flushing unit in question Fernox Mark II machine.Thanks for any help in anticipation!!
 
cant see why not, as long as yu have a circuit to flush around you wont damage anything
 
Status
Not open for further replies.

Reply to Powe Flushing Question in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

S
Hot pulling air through open vent.
Hi, I'm new to the forum and just some background on myself. I have 4 years experience as a plumber but haven't worked in the trade in 15 years. I would say my overall knowledge is not great as I did most of the 4 years working on rinse and repeat estates of houses. I was also quite young and...
Replies
13
Views
583
samuelmaccarthy84
S
S
    • Funny
Pressurizing a vented cylinder
Hi guys, I have a question regarding converting an open vent system (copper cylinder) to pressurized, reason being not enough drop from the loft to power a shower, while i know the common advice is to buy a special unvented cylinder I can see no reason why an unvented copper cylinder cannot be...
Replies
13
Views
1K
Timmy D
T
C
Pumping over on vented system, despite cleaning, new pipework and ..
… praying to the plumbing God, Bob Pictures and layout details attached, so be patient. 21 year old oil fired system in pretty good nick. I noticed some minor pumping over from the vent (occasional burst of water, and the odd dribble). Didn’t think much of it as I was about to replace the...
Replies
7
Views
1K
Coddey
C
dave100
New unvented cylinder / Replace old vented cylinder and add a ST pump?
Hello, I am renovating a small bathroom in an apartment on the 5th floor. Heating is electric, no gas or oil. I have four (related) questions about this below. I had intended to reuse the cold water tank and the cylinder sitting underneath it but my plumber suggested I replace the cylinder as...
Replies
1
Views
766
fowlerboi
F
C
    • Like
Grundfos Alpha Pump replacement
Hello, my Mothers heating failed in the recent UK cold snap. I found the pump was stuck. I have a question about pump orientation. The existing pump flows downwards. The manual for the proposed replacement recommends that it should pump upwards. This would involve rearranging the flow &...
Replies
8
Views
626
Clockdoc
C
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Electricians' Talk
Tiling Standards BS5389
Electrician Talk Forum
Tiling Blog
Tiling Advice Live
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock