Search the forum,

replace

In computing, replace is a command that is used to replace one or more existing computer files or add new files to a target directory. Files with a hidden or system attribute set cannot be replaced using replace. The command lists all files that are replaced.

View More On Wikipedia.org
Recent contents Top users
  1. D

    plumber to replace bath with shower tray

    Sounds simple but I have already had a withdrawal. I live in Hull. The bathroom floor is very thick concrete because I live above a set of garages. Interested?
  2. P

    Replace basin sink tap head covers please

    Have a sink basin tap photo attached and need to replace the heads as behind they have cracked. Any idea where I can get replacement tap head covers only need to change the tap head covers really Problem is the old tap head covers wont turn! Any ideas please? Thanks
  3. whitehalls

    Can I replace this sprout?

    Hi, I need to replace the sprout of this faucet. Is it possible to unscrew and change just this part? It has a tiny hold due to rust and water leaks out from it. Thanks
  4. U

    Replace stop-tap/stopcock

    Hi all, I joined today and am a newbie at plumbing DIY. Thought I'd share my experience replacing the stopcock under my sink. The old one looked very corroded around the tap handle. An Anglian Water engineer was at the property measuring my water pressure and flow rate. When he saw the...
  5. T

    Should I Replace Hot-water Cylinder?

    I have a vented hot-water cylinder that was installed when the house was built - 38 years ago! It has a header tank in the loft and the cylinder is located directly above the ceiling of a new and expensive kitchen. It does not leak and causes no obvious problems. Should it be replaced? Advice...
  6. SteveP205

    Plumber to replace Mainsboost MJ3 Charger

    The MJ3 Charger on my Mainsboost system has stopped working and I have sourced a replacement, but need a plumber that understands these installations to come and replace that unit and ensure it's commissioned properly. Let me know if you've worked with this system before and can quote on...
  7. V

    pricing costs / labor time to replace flexible coupling

    Good morning, I thought I would try here first before going elsewhere. in short I had a septic system flexible coupling needing replacing. Backed up waste water. It was less than a meter down and took plumbers less than 1/2 to diagnose I was charged $1560 originally Spoke to plumber to contest...
  8. D

    Need to replace plastic trim on shower track

    Hello, I fitted a Cooke and Lewis shower cubicle about 5-6 years ago. The weight of the glass shower door has put large impressions of the roller wheels in the plastic track the rollers run on. Got worse over the years and now it is quite difficult to open and close the shower door. I took some...
  9. higerboler

    How to replace the water pipes in bathroom?

    I have just moved into a flat and the water waste pipe from the flat above goes through our bathroom. And the water comes into room. I call the flat owner to say my problem but he don't interest him. I am there to find a talented plumber. Please reply me.
  10. R

    Replace Aqualisa power shower to mixer shower

    Hi - I want to replace Aqualisa power shower to mixer shower to a std. mixer shower, however, the centres for the hot and cold are only 65mm. I’ve tried finding something that would be compatible but no joy. Ideal would be a mixer head with the same centres. Does anyone have any idea as to...
  11. T

    Job in Leyton E10 - Cast Soil Stack Replacement

    I need a quote to replace a soil stack ( cast ) in Leyton e10. The stack is already in plastic at the bottom. There also needs to be amendment to branch to accomodate a change of position of the bathroom in the upstairs flat. BTW - this is one up/ one down flat arrangment. There is access to...
  12. dave100

    New unvented cylinder / Replace old vented cylinder and add a ST pump?

    Hello, I am renovating a small bathroom in an apartment on the 5th floor. Heating is electric, no gas or oil. I have four (related) questions about this below. I had intended to reuse the cold water tank and the cylinder sitting underneath it but my plumber suggested I replace the cylinder as...
  13. B

    How do I replace a double-check/non-return valve?

    I need to replace the double-check/non-return valve on the pipe that goes out to the back garden tap under the sink. I got the correct replacement part, but I am not sure actually how to remove the original non-return valve on the pipe. When I loosen the two nuts, it can slide a bit back and...
  14. M

    Replace back boiler with electric

    Hi, would it be feasible to replace a baxi bermuda back boiler with an electric boiler, situated on the side of the chimney breast, utilising, mostly the existing pipework, cylinder etc.
  15. M

    Help! Replace kohler diverter valve

    Hello. I have a Kohler Rite-Temp® 1/2 in. Pressure Balancing Valve with Stops. The diverter needs to replaced and I got the replacement part already. Opened the trim easily. But don’t seem to be able to unscrew the silver trim off the stem (red arrow in the photo). Can’t see why it doesn’t...
  16. P

    Cost to lift floor and replace kitchen waste pipe

    We have just had a drain specialist in greater Manchester who said that our builders (uncontactable) laid our 40mm pvc waste pipe from the kitchen island to outside (about 3 meters, suspended floor, just about a crawl space underneath when floor lifted) too flat and there’s standing water, smell...
  17. E

    I want to replace a Danfoss T6360B with Digital One?

    How to replace an old Danfoss T6360B manual thermostat with a digital one suggestions please?
  18. S

    How to replace UFH return pin valve

    Hello, I have UFH set up with a HIU in my flat. My issue is that one zone (Bedroom 2) does not heat up. All other zones working and heating as expected. Have checked the relevant thermostat, as well as the electrical actuator for the specific zone. Both look ok Checked return pin valve -...
  19. chris skeats

    URGENT Hi I am thinking to replace my ageing Alpha CD24R with a Bosch

    Hi I am thinking to replace my ageing Alpha CD24R with a Bosch equivalent, I have a few quotes which seemed fair, until today we had a company turned up, he really had a good look round. Far longer than the others, (one i had to send pictures ? And he quoted me the pics that I supplied?) He...
  20. P

    Replacing Heatmiser UH2 with updated model

    Hi all, I have a Heatmiser UFH installation, 7-8 years old now. This week we noticed that a few of our heating zones were not warming up, even though the thermostat was showing the flame symbol. They were working fine last winter. I knew from when I looked at the installation in the past that...
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock