Users can remove all display ads (not sponsors) for a small fee. Click for info (must be logged in)

Discuss Potterton E168 error code in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

ISM

Plumbers Arms member
Plumber
Gas Engineer
Messages
48
E168 error code, what the f**k is going on here. can anyone please help!? I turned the boiler off at the board (no fuse spur and old style mains board) to drain down and install new pipework. Turn back on, wam bam thank you mam, E168!! What the F**k!
 
I had this couple weeks ago , its an electrical fault , 9 out of 10 times its the pcb,,,,, the so called ghost code . but no code E168 in the MIs,,
 
Sometimes you can fart around and get it back if lucky ,,, The one i had 2 weeks ago was E133 , and E119 , and while fixing it i had the E168 , i changed the pcb and the pressure sensor and all was well , but before i fixed it the E168 came up but managed to get it going again till i ordered the new parts ,
 
E168 error code, what the f**k is going on here. can anyone please help!? I turned the boiler off at the board (no fuse spur and old style mains board) to drain down and install new pipework. Turn back on, wam bam thank you mam, E168!! What the F**k!

Rule one,no swearing,even asterixed swearing ,no issue with it in the arms but not in here or the open forums,Rule 2,its normally the pcb,but not always,i can talk you through it but unless you are fully conversant with a multi meter,its pointless
 
Status
Not open for further replies.

Reply to Potterton E168 error code in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the...
Replies
5
Views
322
Hi they used to say as a last resort you could discharge the D2 pipework at high level and turn it back to the wall. Similar to a combi boiler. I...
Replies
11
Views
348
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
217
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16...
Replies
0
Views
235
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to...
Replies
6
Views
284
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock