Discuss End feed job lot ebay in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
ive looked at this listing a few times , let us know if its worth it if you do buy. am too scared to spend my money but dont mind spending yours phil

60 straights is a lot mind
 
My problem is I just don't have time to go to merchants, I do bathrooms most of the time and they are hard long days so I have to order most things in.
 
fair but no better than what available in a merchants. pts/drakes/hps all do similar fittings packs for about ÂŁ55 that consist of 150 fittings mix of 15/22 straight 90's tee's reducers. so if it were me id rather get the fittings pack
 
End of day the custard pays for whatever we buy :)

End feed are cheaper than solder rings but then lead free solder is going up and up in price too!

Is it cheaper than beeandkew?
 
Leave em alone, expensive. 19.99 + 5.95 Delivery 25.94

Can buy the same fittings at Tool station for 20.26 delivered free.
 
Leave em alone, expensive. 19.99 + 5.95 Delivery 25.94

Can buy the same fittings at Tool station for 20.26 delivered free.

damn!.
just worked that one out before i seen your post.lol
yup about ÂŁ20 and you wont need that amount of couplers which a re the cheapest fitting in e/f
 
It is not a good buy.

Same stuff from bes

60 x unions ÂŁ4.20
30 x elbows ÂŁ5.40
10 x tees ÂŁ3.70

ÂŁ13.30 + vat = ÂŁ15.96 + delivery ÂŁ4.95 (free if over ÂŁ40 spent) ÂŁ20.91
 
Status
Not open for further replies.

Reply to End feed job lot ebay in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi guys Bit of frustrating situation, I was preparing to solder a 15mm Tee by lining it up to get the positioning right, etc and it was quite...
Replies
4
Views
200
Hello, I have just installed a vented McDonald 250L thermal store, it is for multi fuel but currently just connected to a standard oil boiler in...
Replies
22
Views
1K
We have a utility room with a washing machine but no sink. Wife wants sink. There is room to fit one and the waste will connect to wahing machine...
Replies
22
Views
561
Hi I've had to cut hot and cold feed to re route for bathroom feeds. The 22mm Copper pipe hot feed is slightly smaller then my 22mm Copper...
Replies
3
Views
544
Hi, Short version: I have about 4" of pipe sticking out of a concrete floor in a cupboard. It makes a 45-degree bend as it exists (bent, not with...
Replies
14
Views
1K
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock