Anyone coming across these tap fixing components. I'm struggling to find a box spanner to fit. The nut is about 33-34 mm between flats. New install and as far as I can see nothing apart from a box spanner will tighten this. Unless you have the opportunity fit before installing sink.
Discuss Monobloc kitchen mixer 32mm back nut - spanner in the USA area at PlumbersForums.net
- Messages
- 34,369
- Solutions
- 2
Deep socket
- Messages
- 21,052
Sounds like a ****o.
Don't think so, not enough room anyway. I did eventually find a 34mm/40mm box. I wasn't sure the sockets would be deep enough. They are pricey also. Thanks for the suggestions. Waste of time as the tap is sh......te a cheap Flexi pull down mixer. I've no doubt it will be replaced before long -
Reply to Monobloc kitchen mixer 32mm back nut - spanner in the USA area at PlumbersForums.net
Similar plumbing topics
Trying to fit a mixer tap with this sort of fastening. Bit that goes up inside the tap is like a threaded running nipple but when fully screwed in...
Morning everyone,
I need advice on how much the following should roughly cost as I need my kitchen tap to be replaced as well as adding isolation...
Hi guys. I moved into a house where the kitchen was moved from an upper floor to the ground floor, at the back of the house, so there was no...
I have an Albion indirect mainsflow thermal store installed in July 2011 with a 120 litre capacity.
I live in a block of communal council flats...