Search the forum,

Discuss halstead acehigh combi in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
P

pauls

is there any reason why on the boiler auto air vent the little black screw cap is missing and a clear plastic tube attached running out at the side of the boiler.

the auto air valve is leaking from where the little black cap goes so i cant see any reason why i dont get a spare cap and screw it on.
 
cos the aav is leaking and the pipe is draining away the leaking fluid, so replace the aav and alls well
 
These boilers have a short discharge tube attached as standard. The cap should be removed.
If there is a visible discharge replace the AAV and re-fit the tube.
 
the little tube is a very god idea,went to a Worcester the other day that had wet its pcb from a failed aav
 
Status
Not open for further replies.

Reply to halstead acehigh combi in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
201
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Replies
5
Views
264
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
339
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
252
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
189
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock