Discuss HALL of LEGENDS photo gallery. in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

AlexGas

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
2,849
Let’s show the British people what we can do!

Untitled-2.jpg

Untitled-1.jpg
 
just out of interest, how do you get to the trap on that basin?.

There’s a full access to the trap and ISO’s through the hole. It’s just other side of the tile and 18mm ply. The bottom of the trap is almost in line with the top of the opening.
The panel behind the WC is removable.
 
Last edited:
Very nice job. Must have a tile table saw for them cuts above the worktop.
 
Very nice job. Must have a tile table saw for them cuts above the worktop.

Cheers. The worktop comes to the tile and the bottom edge of the skinny tile is within the thickness of the worktop. I’ve used a wet cutter.

Well… The customer has changed her mind 3 times on what to have under the wash basin and by that time I’ve done the most of the tiling. I didn’t really want to have that grout line so close to the worktop but that’s the way it goes. Also I couldn’t really go any higher with the wash basin, I think the top of the wash basin ended up being 850 ish of the floor. I did point the lot to the customer and she was fine with everything.
 
Beautiful finish, very impressive!

Check the batch numbers on the tile boxes next time though buddy, the vanity unit colours a little different to the wall tiles.

Stay tuned for more crappie jokes! :)

Good job AlexGas.
 
That’s what the customer wanted. It’s fully removable. What’s wrong with that? I take it you are not big on them.
Not having a go Alex, if you can get it off ok, but every one I go to is nailed on or screwed on LOL .
 
Nope none required.
There would already be a vent in room fir the bbu wouldnt there. No doubt wallpapered over.....

Whats that beliw the fire? Did you leave a boo-boo or is it a remote sensor? Cant tell from my phone
 
Last edited by a moderator:
Remote sensor. What a horrid thing to fit! Thatnis the temp sensor. Mark on wall is nothing to do with fire
 
Last edited by a moderator:
OK, hit me! Nearly done... It’s all about the cable, will do it tomorrow…

il30.jpg
 
The mark next to the 22 elbow was there before.

mains.jpg
 
Last edited:
Just spent 20 minutes uploading pictures from my old phone and got timmed out. I'll add more once they're on a pc
 
All done, should get paid tomorrow. Another Logic is on the wall, supplied by the best plumbing merchant on the south coast - Williams & Co Ltd.

logic.jpg
 
Status
Not open for further replies.

Reply to HALL of LEGENDS photo gallery. in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Got a bath which is just over 10 years old and the shower head needs replacing. This photo shows the layout. I appreciate that access will be...
Replies
3
Views
128
Hi, We have noticed for a while now that when our washing machine nears the end of a cycle we get a bad smell of dirty water in the downstairs...
Replies
3
Views
279
I need to replace the washer of my kitchen mixer tap as it is leaking. I was able to remove the spout once by unscrewing the screw on the back of...
Replies
9
Views
480
Hi everyone, I've joined the forum today as I've found myself going round in circles with what I think might be a pretty simple problem, hoping...
Replies
4
Views
402
Do you recognise this shower drain rubber seal? I have searched the web and common plumbing spares suppliers but I cannot find which it is. It...
Replies
1
Views
113
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock