Search the forum,

Discuss Gas engineer Manchester stockport in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
L

LiamGray



Hi all! I am relatively new. I am looking for full time employment as a plumbing heating engineer. I am gas safe and have all my ACS's. I am 28 and live in Macclesfield near Stockport Manchester . Any help would be great . Thanks.
 
Hi Liam and welcome hope someone here can help with your quest......regards Turnpin:welcome:
 
Send a p.m to Gas man or Red saw with your gas safe no answer a couple of gas related questions and you can gain entry to the gas section of these forum's........regards Turnpin
 
Hi Liam and welcome along ,
 
Status
Not open for further replies.

Reply to Gas engineer Manchester stockport in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi All, I am looking to take my bath out and fit a shower. Regards to tanking. Is it ok to just seal everything with plastic rather than just paint tanking slurry? Thanks in anticipation, best regards Staggers
Replies
3
Views
166
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
5
Views
496
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
154
I am in process of replacing an existing sink with a new stainless steel one. The existing tap is plumbed directly to copper which means that it is earthed. The new tap will use flexible tails and so will not be earth bonded. My initial search for information suggests that there is no legal...
Replies
6
Views
265
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Replies
5
Views
276
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock