Search the forum,

ContractorForum: what little story lead you into the tiling industry then: please tel

Post new thread

Discuss ContractorForum: what little story lead you into the tiling industry then: please tel in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Status
Not open for further replies.

Reply to ContractorForum: what little story lead you into the tiling industry then: please tel in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
168
Lou
Lou
Lou
Show us your fanciest radiators you have installed!!
Show us your fanciest radiators you've installed! We would love to see them! I love this Milano vertical radiator in the kitchen space. What do you think?
Replies
4
Views
230
Timmy D
T
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
215
dreikher
dreikher
P
Viessmann combi starts when cold, mixer, tap is opened
Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
222
ShaunCorbs
ShaunCorbs
M
Viessmann external flue run conundrum
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
230
mutley racers
M
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tiling Forum
Tile Talk
UK Tiling Forum
Tile Advice
BS 5389 Tiling Standards
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock