Search the forum,

can anyone give me some studying sources?

Post new thread

Discuss can anyone give me some studying sources? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
S

Smcart5

I just failed my hot water exam as part of the course i'm doing (mainly because most of the questions were about things not covered in the course)
Can anyone recommend some reading material on hot water systems, specifically the areas that the 6129 tech cert covers.
 
Book:

Plumbing NVQ and Technical Certificate: Level 2

Website: SmartScreen : Home - A very useful site from City & Guilds, gives example questions and answers and some very useful information. Also because its from City & Guilds you know that its going to be included in the course.
 
Status
Not open for further replies.

Reply to can anyone give me some studying sources? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
318
oz-plumber
O
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
166
Lou
Lou
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
213
dreikher
dreikher
D
Covering shallow sewer pipe under concrete Patio
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
268
DIwhYdidIstartThis
D
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Electrical Forum for Electrical Advice
Tiling Forum
Tiling Forum UK
UK Tiling Forum
Contractor Advice Forum
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock