Search the forum,

Discuss Shower drain cover replacement help in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Messages
4
20190922_151412.jpg

I need some help please. I am looking for a shower drain cover for this drain. I dont know what make it is. This is in a wet room shower.
 
I just need the cover that fits with this drain

CHK is suggesting Regal Bathrooms as a potential supplier. They do a lot of wet rooms so may have the part or know where to get it. Unfortunately a lot of manufacturers don't sell single parts from their waste systems and you have to buy the whole shower waste to get the part you need.

You never know you might get lucky though.
 

Reply to Shower drain cover replacement help in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
231
S
I have a brand new, unboxed shower/wet room screen from KRION purchased from Porcelanosa UK. It is the Attica 1 model, as shown in the attached picture from their catalogue. Like on this image ->...
Replies
0
Views
46
Sebastian T
S
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
519
Hi All, I am looking to take my bath out and fit a shower. Regards to tanking. Is it ok to just seal everything with plastic rather than just paint tanking slurry? Thanks in anticipation, best regards Staggers
Replies
3
Views
108
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
136
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock