Discuss Removing copper soil stack in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
20
hi.
I have a copper soil stack (def copper) that I am hoping to take out, runs through the house, pops out the roof, which is leaking anyway!

What’s the best way to connect? I plan on cutting a couple inches before the pipe goes underground, can I stick a connector in, assuming it fits like
https://www.NoLinkingToThis/p/mcalpine-dc1-bl-drain-connector-black-110mm/4255v

Or is it easier to use a large flexible connector? If it’s clipped correctly, surely this is fine?
Can get pics tomorrow if needed

Cheers
Edd
 
It really needs to be replaced into the ground, it shouln't be too far down.
The connector in your link will work into the copper.

I work on commercial and we have a lot of copper soil pipe.
It nearly always ends up leaking at floor level.
 
Cheers for replies.

Have attached a couple of photos,
05CC2717-783C-49D0-BEED-C109F2BA9650.jpeg

156D7D80-6DD8-4656-B406-70440B162BD7.jpeg


So just chisel the cement mound away and I should see where the copper goes to the underground drain?

Then do I use the connector in the clay drain(buried), and cement it all back in (including inch or so of plastic pipe)
Or just pull it close, silicone and cement?

Cheers
Edd
 
I would get the grinder out bud get it all stripped out chip out the cement work out at low level to free the lowest part of the copper into the ground when you have make sure no mortar falls in the drain a black bin liner with screwed up news paper in push in the open will protect it clean out the collar then cement in a access pipe with a 110mm collar then is time to reinstall the stack . Kop
 
Never seen a copper soil stack before. Any pics showing how any connections were joined to it?
 
Same as that. It's usually asbestos, cast, plastic or steel. Bet that's worth a fortune in scrap!
 
Status
Not open for further replies.

Reply to Removing copper soil stack in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi all, Have got an old 60/70s PVC soil stack, the Toilet is going into a Hunter branded socket which has an old O-ring design (quite flat with 3...
Replies
2
Views
569
As part of a slow DIY bathroom refit I've removed the old toilet from the original location next to the soil pipe (and obviously capped off the...
Replies
4
Views
714
Hi all, Quick question. Is there a difference between the black soil stack coupler and the brown outdoor pipe coupler other than the colour? My...
Replies
5
Views
2K
I'm trying to pull a Polypipe SA62B access plug and cap out of the soil vent branch (which I think is a Floplast SP190). It's a bit of a cramped...
Replies
7
Views
2K
Hello, I would very much appreciate some help/feedback on what I am proposing for my very small ensuite bathroom. While refurbishing it I’m...
Replies
1
Views
4K
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock