Search the forum,

Remove reducing olives

Post new thread

Discuss Remove reducing olives in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Cut the pipe below the reducing set
 
Blushinglad said:
Is that with a hacksaw or pipe cutter?
Click to expand...

Hacksaw will get you closer so you won’t loose / shorten the pipe as much as a slice / cutter
 

Reply to Remove reducing olives in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
221
SimonG
SimonG
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
211
dreikher
dreikher
johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
285
exedon2
exedon2
P
Viessmann combi starts when cold, mixer, tap is opened
Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
221
ShaunCorbs
ShaunCorbs
jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
314
oz-plumber
O
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tiling Blog
Tilers Forum
TilersForums.co.uk | UK Tiling Forum - Est 2006
DIY Talk
Tile Talk
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock