Search the forum,

Peak hour and annual gas consumption

Post new thread

Discuss Peak hour and annual gas consumption in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
U

Umut Calkam

Dear all,

Can anyone please explain me how to calculate peak hour and annual gas consumption in kW? After a very long hours searching on the Web, no satisfactory answer was found.
Many thanks
 
Status
Not open for further replies.

Reply to Peak hour and annual gas consumption in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

F
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
5
Views
399
FozzieBear
F
jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
281
oz-plumber
O
P
Viessmann combi starts when cold, mixer, tap is opened
Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
195
ShaunCorbs
ShaunCorbs
sammie81116
Sewer pipe problems not sure about it
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
475
Chuck
C
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
182
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock