how to replace a hot water cylinder with a combi bolier

[lukev1]

hi i am a apprentice plumber and i am on a trial run with a gas registered plumber and we will be replacing a hot water cylinder with a combi boiler and i wanted to know how this is done so i have some knowledge for when we do the job on Monday. can anyone help?????

 

[lame plumber]

isnt this the reason your working with someone as an apprentice? go learn on Monday, if you start telling a potential employer how and why you wont get any jobs, but if you go and fetch and carry quickly and leave your bloody mobile at home you might get back on tuesday.

 

[galaxy_plumbing]

just listen to him and dont sit down.

 

[Barbeck]

s-plan y-plan ?

 

[gasmanrob]

As above, keep your phone in your pocket and on silent too. Break times be the last to sit down and first to stand up ready to get on. And never, and I mean never interrupt pop master

 

[Barbeck]

isnt this the reason your working with someone as an apprentice? go learn on Monday, if you start telling a potential employer how and why you wont get any jobs, but if you go and fetch and carry quickly and leave your bloody mobile at home you might get back on tuesday.

I think an apprentice that does there homework is just as good as a dog

 

[lame plumber]

I think an apprentice that does there homework is just as good as a dog

........?

 

[Ermintrude]

Basically you get ch pipes from wherever you can and the hot and cold. You chop out all the gear you don't use. You probably get sent in loft to strip out tanks.

1 make sure they are dry

2 ensure you know what each pipe is before you remove as you may find that there is a balanced cold from the cwsc to main bathroom bath / shower

 

[lukev1]

As above, keep your phone in your pocket and on silent too. Break times be the last to sit down and first to stand up ready to get on. And never, and I mean never interrupt pop master

ok thanks

 

[lukev1]

y-plan