Search the forum,

Discuss Is Pressure checked at same time of hot water cylinder repair in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

J

Johnno1966

Hello, hoping someone can advise me. My boiler stopped working - no hot water or central heating. Called out a company who came and assessed the problem as being that the hot water element in the immersion tank needed replacing. (I don't know exactly what it is called as the company has still not provided me with a receipt or an invoice despite requests).

The repair was done and there was hot water and central heating for 24 hours.

I informed the company that there was no hot water again, and they came out and said that actually they now needed to replace the Red Heating Expansion Vessel and sealed System Kit which they were going to charge me a further £120 on top of the £514 they charged to do the repair immediately on completion (I think my red tank is 8L). I wanted to do my own research on costings and they really tried to pressurise me in paying for the part there and2 then as they could do the repair today but if I didn't agree to do it today they would charge me for a whole new job and part. I refused and told them to leave.

My questions are:
1. is it feasible that after doing the repair on the element, wouldn't as a matter of course the pressure be checked? (especially as the tank is at eye level above the hot water cylinder?).
2. Can I request a refund (full/partial) as the fix only lasted a day?
3. What grounds could the company give for refusing to give a refund?

I urgently needed to have the repair done and didn't research prices - £514 is a lot for less than 60 minutes of work (Greater London) and a new part.

Any advice and guidance would be gratefully received.
 

Reply to Is Pressure checked at same time of hot water cylinder repair in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
286
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
322
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
494
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
186
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it 😬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
263
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock