Search the forum,

hep20 help needed.

Post new thread

Discuss hep20 help needed. in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
G

gasso

is anyone experienced with hep20 plastic 22x10mm 4port manifolds.they differ from the other fittings (bends ts etc)slightly, are the10mm ports demountable.ive tried and had no joy.help!
 
I though all the Hep2o range was supposed to be demountable... Have you got the proper key for it?
 
got the set.dont even need them to remove pipe from bends ts etc.but the manifolds have different ends.
 
Sounds like your using a mix of fittings, as far as I know all Hep fittings are white now and all require the demounting tool to remove pipe from them? You got a photo?
 
Status
Not open for further replies.

Reply to hep20 help needed. in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
217
SimonG
SimonG
B
What is correct toilet supply line
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
198
ShaunCorbs
ShaunCorbs
M
Viessmann external flue run conundrum
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
225
mutley racers
M
jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
313
oz-plumber
O
D
UK Pipes for thermostat shower fitted at different heights
Pipes for thermostat shower have been fitted at different heights. Any way of rectifying without ripping all tiles. So for clarity 15mm pipes sunk into wall behind bath. Walls have fresh tiles. Have realised as about to fit shower these pipes one is set higher than the other. If you fit a...
Replies
2
Views
178
fowlerboi
F
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tile Talk
Tiling Forums UK
Tile Advice
Electrical Forum for Electrical Advice
Electrical Forum
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock