Search the forum,

Discuss hep20 help needed. in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
G

gasso

is anyone experienced with hep20 plastic 22x10mm 4port manifolds.they differ from the other fittings (bends ts etc)slightly, are the10mm ports demountable.ive tried and had no joy.help!
 
I though all the Hep2o range was supposed to be demountable... Have you got the proper key for it?
 
got the set.dont even need them to remove pipe from bends ts etc.but the manifolds have different ends.
 
Sounds like your using a mix of fittings, as far as I know all Hep fittings are white now and all require the demounting tool to remove pipe from them? You got a photo?
 
Status
Not open for further replies.

Reply to hep20 help needed. in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

  • Sticky
Morning to any Australians lurking around! Register its free, then message me, I'll sort your account out for you. We will need a moderator from each main country too. I'll post this in the Australian forum now.
Replies
0
Views
59
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
201
IS IT POSSIBLE TO ADJUST THIS MIXER UNIT? WE HAVE TO HAVE IT TURNED ALMOST FULLY ANTI CLOCKWISE TO GET HOT WATEROUT. THE FRONT PLATE WITH MIRA ON IT PRISES OFF AND INSIDE THERE ARE SOME PLASTIC BITS AND A SMALL CROSS-HEAD SCREW IN THE MIDDLE. THANKS
Replies
6
Views
195
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock