Search the forum,

ATL Practical Training

Post new thread

Discuss ATL Practical Training in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
G

gogo

Can anyone please tell me if the plumbing course (Domestic Renewable Energy) is appropriately accredited.
Any info will be appreciated
 
Status
Not open for further replies.

Reply to ATL Practical Training in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
110
Lou
Lou
L
My son has an Apprentice interview- please help.
My son has an apprenticeship interview for to become a plumber and heating engineer. The have said there will be a multiple choice exam for this for suitability. The thing is my son panics during tests/exams. Is there any book I can buy him to practice the multiple choice test for the exam? What...
Replies
3
Views
407
Chuck
C
P
Viessmann combi starts when cold, mixer, tap is opened
Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
200
ShaunCorbs
ShaunCorbs
jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
286
oz-plumber
O
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
186
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock