Users can remove all display ads (not sponsors) for a small fee. Click for info (must be logged in)

3 branch soil fittings

Post new thread

Discuss 3 branch soil fittings in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
M

mutley racers

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
5,172
Are there any? As in left, right and centre.Or not, as you are not allowed to connect toilets opposite each other due to crossflow? I hope that makes sense. Basically, i have a ladies toilets to plumb in and the soil pipe comes in right at the centre of where the toilets will be. So two to the left and two to the right?

Cheers fellers
 
Thanks tamz, I think you have told me about these before. But, if i use them, is there a way to prevent against crossflow
 
Do you mean like this?

Polypipe SU420

crosstee.jpg
 
OK, I have seen corner tees, and double branches, but I must confess I haven't seen one with another sideways input. Not above ground, anyway.
 
Ray Stafford said:
OK, I have seen corner tees, and double branches, but I must confess I haven't seen one with another sideways input. Not above ground, anyway.
Click to expand...

Marley, polypipe and the usual suspects all do them Ray.

No they don't. I should read before i type :smile:
 
Last edited by a moderator:
Love the special corner branches etc that have clearly been glued together with solvent weld.

I'm intrigued as to why you need this fitting!
 
Can you rejig the room two left and two right? the middle one will only have to go a few inches to the left.
 
TBServices said:
Love the special corner branches etc that have clearly been glued together with solvent weld.

I'm intrigued as to why you need this fitting!
Click to expand...

I always thought of making my own with a tube of gap filler as when you see them it looks like thats what they do anyway but could never be bothered to try it.
 
TBServices said:
Love the special corner branches etc that have clearly been glued together with solvent weld.

I'm intrigued as to why you need this fitting!
Click to expand...

I have such little space to work with it is pretty much all I can use without chasing massive holes in church walls which are made of granite. It took me 7hrs to core 1 hole about a metre long
 
mutley racers said:
I have such little space to work with it is pretty much all I can use without chasing massive holes in church walls which are made of granite. It took me 7hrs to core 1 hole about a metre long
Click to expand...

Lol! I get it now.

Do you have 5 toilets all in a row with the soil behind the centre one?
 
Where's the church mutley ? I'd love to see this configuration when you're done
 
I am going to be using a stub stack system for the 1st time, and I am wondering if I should put 2 durgo valves in? One on the end of branch of toilets? Or will just one main one be ok?


Who would have thought you would get some many replies to a soil pipe fitting a
 
Well it turns out lads that, I actually only need a cross section branch. Measured it all up and the pipe doesn't pop up through the floor right on centre with pan. Thanks for all the advice. I guess we all learnt a bit from this. Me, never listen to what the builder says you need without visiting the job and some of you guys, that there are 3 brach fittings.
 
New posts
Status
Not open for further replies.

Reply to 3 branch soil fittings in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
207
Lou
Lou
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16...
Replies
0
Views
228
dreikher
dreikher
R
squeaky grohe bathroom tap 2 months old
Hi bit of a weird issue, I installed a grohe bathroom tap successfully 2 months ago bought from screwfix. Last week the right hand hot tap makes...
Replies
7
Views
474
Raff
R
P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4...
Replies
9
Views
426
Chuck
C
P
LCS to new water mains
Hi, I have an old steel water mains pipe (approx 45mm) that I need to connect to a new pehd water mains (25mm). I can't get at it to create a new...
Replies
2
Views
236
ShaunCorbs
ShaunCorbs

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock