B
baj25
Hi All,
Thanks for the info I've had by lurking on these forums for a while, but now I have a problem I need to ask about. I'm fitting a 3 hole bath filler and taps as in the photo. The horizontal connection on the right is a normal 3/4 tap connector, but the bottom connection on the tap (vertical), and the 2 connections to the filler are 3/4 parallel thread with flat ends. The pipework is 15mm copper, so I've used 15mm compression x 3/4 BSP Fem to connect (as in RH pic). (The bath pic shows a tap connector but ignore that). I've used fibre washer + PTFE to seal, and then fibre washer + hawk white, and I cannot get it water tight after 4 attempts. I need to bottom this pronto to get on with the rest of the job- any suggestions please? TIA, Brian
Thanks for the info I've had by lurking on these forums for a while, but now I have a problem I need to ask about. I'm fitting a 3 hole bath filler and taps as in the photo. The horizontal connection on the right is a normal 3/4 tap connector, but the bottom connection on the tap (vertical), and the 2 connections to the filler are 3/4 parallel thread with flat ends. The pipework is 15mm copper, so I've used 15mm compression x 3/4 BSP Fem to connect (as in RH pic). (The bath pic shows a tap connector but ignore that). I've used fibre washer + PTFE to seal, and then fibre washer + hawk white, and I cannot get it water tight after 4 attempts. I need to bottom this pronto to get on with the rest of the job- any suggestions please? TIA, Brian