Discuss Best place for end feed or capillary fittings in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

Nick Cox

Gas Engineer
Messages
29
I am looking for a good place to buy in bulk end feed and capillary fittings, I have looked at BES but don't think they are very cheap can anyone recommend anywhere please.
 
Try Williams, not always the cheapest though!
 
IF you want decent ones get yorkshire branded end feed ones
 
Do you need to buy in bulk ? just means you have loads of stock sitting around, unless you have a high volume of work its not always worth the outlay.
 
Do you need to buy in bulk ? just means you have loads of stock sitting around, unless you have a high volume of work its not always worth the outlay.

Agree , I used to by too much in bulk , but have stopped now , however generally buy of JTM plumbing , good value and superb delivery
 
I just thought it would work out cheaper to buy in bulk and I would not have to keep going to merchants for just 1 item
its awkward when there is no local merchant where your working
 
I just thought it would work out cheaper to buy in bulk and I would not have to keep going to merchants for just 1 item
its awkward when there is no local merchant where your working
I use the Stanley storage box's and find they hold enough for every day use (common fittings 15 & 22) if you get the deep case its surprising how meny they hold, larger jobs just buy extra as needed, and you don't save that much buying in bulk, + you tend to loose quite a lot rolling around in the van
 
Try Williams, not always the cheapest though!
Ive been doing some book work today and I have found Williams not cheap at all. Local builders merchants that we use for example are 25% cheaper in the same month for everyday material such as pipe and fittings I was surprised today when I looked and found that screwfix are £20 cheaper for a pack copper
 
Ive been doing some book work today and I have found Williams not cheap at all. Local builders merchants that we use for example are 25% cheaper in the same month for everyday material such as pipe and fittings I was surprised today when I looked and found that screwfix are £20 cheaper for a pack copper

Yep always said they weren't but service is ok
 
Status
Not open for further replies.

Reply to Best place for end feed or capillary fittings in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
227
Hi All, I am looking to take my bath out and fit a shower. Regards to tanking. Is it ok to just seal everything with plastic rather than just...
Replies
3
Views
282
Hi guys....we have an old Astracast sink top....I think its a composite sink....has a big single bowl. My wife thinks it looks scruffy....looks...
Replies
2
Views
237
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about...
Replies
7
Views
262
P
  • Question
Boiler is SIRIUS THREE FS 70 Potterton commercial. Situation: We are small building contractors and my labourers managed to damage the radiator...
Replies
2
Views
144
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock