Discuss Waste size slightly smaller than inch and 1/4 in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
M

mikeyc

Went to an emergency call out today at a hair salon that has a load of foreign basins and traps are all leaking. I need to change them out but my problem is that the waste shank is slightly smaller than inch and 1/4 - like almost fits.

Anyone know any other sizes it could possibly be or suggest where to start looking.

Cheers in advance for any pointers
 
35mm?
 
Went to an emergency call out today at a hair salon that has a load of foreign basins and traps are all leaking. I need to change them out but my problem is that the waste shank is slightly smaller than inch and 1/4 - like almost fits.

Anyone know any other sizes it could possibly be or suggest where to start looking.

Cheers in advance for any pointers

1 1/4 push fit ?
 
No I mean the actual threaded shank on the bottom of the waste is smaller than 32mm so a 32mm trap is too big to screw on. Can't change the wastes as these are a god awful shape, size and design
 
Solvent 1 1/4" is 36mm, push fit is 35mm and Euro size is 32mm.
If it is Euro you will need an adapter like a mcalpine S28
 
As tamz said if it was me i'd swap the wastes out in the sink to standard uk size
 
had quite a number of sink wastes that normal traps wont sit on correctly recently, blumin euro carp.
 
Status
Not open for further replies.

Reply to Waste size slightly smaller than inch and 1/4 in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

I have read a few threads including one by Debbie Stano that were similar to my issue but that thread stopped a while back without any resolution...
Replies
1
Views
1K
C
Hi I have a sink that has the basin plus another smaller basin next to it, think it is a 1/4 of the size of the main basin. The unit comes up...
Replies
2
Views
929
Hi I am not sure whether I have posted correctly earlier today, if so please forgive me as I am trying again just in case. I have a sink that...
Replies
2
Views
740
Hi all, just looking at pipework for a new en suite sink, its slightly smaller then 1 1/4 so I assume I need an adapter of sorts? I was just about...
Replies
5
Views
1K
Hi guys. I moved into a house where the kitchen was moved from an upper floor to the ground floor, at the back of the house, so there was no...
Replies
1
Views
2K
Aquarius
A
Back
Top