Search the forum,

Discuss macerator teaser in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
N

nigel priest

I have a tolet pan connector discharging to the sewer through the floor. I have no external stack. Can a macerator discharge be bossed into the w/c pan connector to allow the macerator to dicharge?
 
I would advise a soil tee peice fitted in place of bent pan connector at rear of existing w/c and a air abmittance valve fitted on top then join macerator outlet into tee

FloPlast Solvent Weld Air Admittance Valve Black AV110 - NoLinkingToThis, Where the Trade Buys
 
I would advise a soil tee peice fitted in place of bent pan connector at rear of existing w/c and a air abmittance valve fitted on top then join macerator outlet into tee

FloPlast Solvent Weld Air Admittance Valve Black AV110 - NoLinkingToThis, Where the Trade Buys

id just use a bent pancon with a inch and a quarter multifit on it you probably dont even need the aav as the macerator has a vent on it and a nonreturn valve on the outlet
if the touilet flushing does pull the macerator pipework it will suck air from the macerator vent smell cant go back due to the non return valve
 
Was not worried about macerator,was worried that normal wc flushed then macerator activated and possibility of part water trap being pulled out of normal pan
 
cant see a threquarter discharge pulling a 4 inch trapobviously if it did then youd rethink but unliklkey
 
Status
Not open for further replies.

Reply to macerator teaser in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
234
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
Replies
2
Views
140
IS IT POSSIBLE TO ADJUST THIS MIXER UNIT? WE HAVE TO HAVE IT TURNED ALMOST FULLY ANTI CLOCKWISE TO GET HOT WATEROUT. THE FRONT PLATE WITH MIRA ON IT PRISES OFF AND INSIDE THERE ARE SOME PLASTIC BITS AND A SMALL CROSS-HEAD SCREW IN THE MIDDLE. THANKS
Replies
6
Views
227
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock