Washer jammed - advice please

[13Black]

Hi, would appreciate some advice.

I had a worn washer on the hot water tap, which was leaking slowly.

I removed the tap body and took it to the plumbing shop as I didnt have right size rubber washer. The guy fitted a new washer for me.

I put the whole thing together again and it was fine for a couple of hours and then no hot water. I took the tap body out and realise that the washer has come out from under the screw that it is supposed to sit into the tap body and is now jammed in the interior of the handle body.

I can see the rubber valve jammed in place and have tried to wedge it out but it is fairly firmly lodged. Any tips on how to get it out?

Apologies if I have got the terms wrong when describing. I just need to know how to get a washer stuck out. Is it a case of getting a sharp knife and working away on it until breaks and prying it out or is there an easier technique.

I think I have learned the hard way that you need to use the right washer. When the guy fitted it, was not flush in terms of its depth. I have taken the tap body out of the cold tap and realised the difference.

Thanks in advance for any advice.

 

[Subby]

Use a flathead screwdriver and just rag it out

 

[Best]

Often just have to butcher it out with a slotted screwdriver.
Sometimes just pushing the slotted blade into the washer hole will let you pry it out.
A pair of long nose pliers are great for reaching the washer.
Perhaps you have used a 1/2" washer on it instead of a 3/8" ?

 

[13Black]

Thanks Subby. I triedthat but the sucker is lodged in tight. It wont budge, hence the thread

 

[13Black]

Thanks for the reply Best. He said it was 3/8 but as I said it didnt fit flush under the screw ie. it wasnt flush with the "casing" it sits in.

 

[Best]

Thanks Subby. I triedthat but the sucker is lodged in tight. It wont budge, hence the thread

Then looks like you will need a hammer & sharp slotted screwdriver to cut it in 3 or more bits!

 

[13Black]

Then looks like you will need a hammer & sharp slotted screwdriver to cut it in 3 or more bits!

Brut force. I can do that! Will give it a go tomorrow.

Sorry if this is a daft question but do different taps have different depth washers? When I've done this before, the washer hasnt needed to sit within a cashing. it simply slotted over a spindle.

 

[Best]

Depth of washer usually not too important, but width (diameter) can cause them to spread too much & jam.
You might have to look around for exact size washers

 

[Terry_the_piper]

So many different types of tap. . . I bought a set of gasket removal tools (Car engine jobie) In it was a bent hook thingummybob which is invalable in such situations. This is similar. 9PC SCRAPER HOOK & PICK GASKET SCRAPING HOSE REMOVAL TOOL SET CHROME VANADIUM | eBay They are also ace for removing kickboards under kitchen unit, lifting fitted carpet corners, picking 'o' rings out of shower bodies &c &c.

 

[13Black]

Depth of washer usually not too important, but width (diameter) can cause them to spread too much & jam.
You might have to look around for exact size washers

is it a daft idea to take the washer out of the cold tap (which is working fine) to see exactly what I need? i cant tell as the one in the hot tap had split and hardly anything was left