Discuss That it should come to this.. in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

Phil

Plumbers Arms member
Plumber
Messages
4,239
After finding my Bosch 10.8 driwall gun is not powerful enough to screw down Hardiebacker I have had to resort to buying another screwgun as getting those sheets screwed down quick in big rooms is a godsend.

I've been through them all and its down to a 240v Bosch (and use my existing magazine) or a stupid 110v Hilti. They don't do a 240v one, also I don't want to spend £650 on a cordless.

So my question is, can I just buy any old £53 yellow box off ebay? I know nothing about them.
 
Last edited:
The 18v one will be able to do it
 
Status
Not open for further replies.

Reply to That it should come to this.. in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new...
Replies
1
Views
288
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
237
S
Hi, I seemed to have a blockage in kitchen sink. A plumber came and cleared all the pipework that is visible inside my home (there was debris and...
Replies
2
Views
167
Sonya K
S
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to...
Replies
6
Views
295
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16...
Replies
0
Views
247
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock