Search the forum,

That it should come to this..

Post new thread

Discuss That it should come to this.. in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
P

Phil

Plumbers Arms member
Plumber
Messages
4,240
After finding my Bosch 10.8 driwall gun is not powerful enough to screw down Hardiebacker I have had to resort to buying another screwgun as getting those sheets screwed down quick in big rooms is a godsend.

I've been through them all and its down to a 240v Bosch (and use my existing magazine) or a stupid 110v Hilti. They don't do a 240v one, also I don't want to spend £650 on a cordless.

So my question is, can I just buy any old £53 yellow box off ebay? I know nothing about them.
 
Last edited:
The 18v one will be able to do it
 
Status
Not open for further replies.

Reply to That it should come to this.. in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
201
SimonG
SimonG
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
140
Lou
Lou
S
Using coil to clear pipe leading to gutter
Hi, I seemed to have a blockage in kitchen sink. A plumber came and cleared all the pipework that is visible inside my home (there was debris and pebbles!) We saw that the pipe that takes water down the gutter was visibly full to the top. He said he will return with a coil to push through...
Replies
2
Views
91
Sonya K
S
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
232
DIwhYdidIstartThis
D
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
190
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

UK Tiling Forum
Tile Cutters
UK Tiling Forums
Tiling Forum
Plumbers Forum - Plumbing Advice
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock