Search the forum,

Discuss Sealing a flue through a fibreglass roof in the Plumbing Jobs | The Job-board area at PlumbersForums.net

mutley racers

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
5,172
Has anyone had to do this? A roofer was installing a new fibreglass roof and said he cannot seal the flue with a flat roof collar to the fibreglass.
Expects me to do the job. He is the roofer so surely he should know how to hey? But alas, I need to work out how this is done.

Cheers
 
Has anyone had to do this? A roofer was installing a new fibreglass roof and said he cannot seal the flue with a flat roof collar to the fibreglass.
Expects me to do the job. He is the roofer so surely he should know how to hey? But alas, I need to work out how this is done.
Cheers

I wouldn’t know how, but have you tried the roof manufactures tech helpline or boiler manu helpline?
 
Sounds like either he can’t be arsed or doesn’t know how to do it, the latter is hard to believe.
All they do is lay the matting and resin up to the top of the flashing tube and the vertical flue collar covers the the upper lip to waterproof it.


Simples
 
i dont see why not so that means you cant install a grp roof when theres a stack pipe going through it

sounds lazy
 
Thanks all. I thought it must be possible. I am really not sure why he couldn't do it though as it is what he does for a living. Contacting a few manufacturers to see what they say.
 
The way i've done it with sold fuel (large 8" od pipe) is get the roofers to raise a bit of 4x2 timber in a sort of box shape and glass up to it in a sloping fashion then fit a dektite over the top.

I've tried to flash band flat aluminium flashings or lead and it allways fails i assume from the expansion on glass??

I've allways wondered if theirs no ceiling in yet, stuff a builders bucket up in through the ply and glass up the side of the bucket then remove it afterwards.......

Hope this helps
 
:D
 

Reply to Sealing a flue through a fibreglass roof in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

  • Article
A Plumber Who Worked Illegally Gets A Suspended Sentence After Falsely Claiming To Be Gas Safe Registered. A Plumber in Herefordshire was prosecuted after Hereford Trading Standards Team found that he was falsely claiming to be on the Gas Safe Register when he was not, putting members of the...
Replies
0
Views
192
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
210
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
314
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
157
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
243
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock