Search the forum,

Identify flush valve

Post new thread

Discuss Identify flush valve in the Plumbing Jobs | The Job-board area at PlumbersForums.net

D

Daflush

Messages
2
Hi, would anyone be able to identify the make/model of this dual flush valve? It has no identifying numbers on it at all, however the separate fill unit has some numbers that might help someone in the know. It would be greatly appreciated, thanks

IMG_20190806_160154__01.jpg


IMG_20190812_200748__02.jpg
 
rpm said:
Can I ask what`s wrong with it?
Click to expand...
It has to be pushed down after flush to reseal the cistern or else water just flows into the pan. It's part of a concealed cistern toilet and the valve sits into quite a tall cradle at the bottom of the cistern. Id happily get a replacement that would also fit the cradle. Thanks
 

Reply to Identify flush valve in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

sammie81116
Sewer pipe problems not sure about it
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
486
Chuck
C
Stigster
Does anyone know the name of this model of Roca toilet?
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
Replies
2
Views
133
Stigster
Stigster
127bit
How to reinforce shower pan threshold?
The left rear floor corner is highest (the shower pan touches/sits on the floor), sloping down diagonally to the front right corner (lowest). The front right corner shim is 5/8", the left front corner is 3/8" shimmed, with shorter shims under left middle and right rear corner. The pan perimeters...
Replies
5
Views
124
Timmy D
T
johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
241
exedon2
exedon2
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
106
Lou
Lou
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock