Search the forum,

Discuss How to??? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

helpsy

Plumbers Arms member
Plumber
Gas Engineer
Messages
1,754
How to connect a combi to an unvented cylinder?
 
Combi hot to kitchen sink then t off heating circuit with all the controls wired up.
 
combis are usually cheaper to buy than similar system boilers also it gives one outlet thats not reliant on the cylinder being heated ive often done it with either the kitchen or the ensuite on the combi which works for families where one works and leaves early without the need to heat the cylinder till later
the other scenario is existing combi in good condition growing family means its not enough to run 2 bathrooms add a small unvented for one and other on combi
 
Last edited:
Status
Not open for further replies.

Reply to How to??? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
218
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
254
Hi they used to say as a last resort you could discharge the D2 pipework at high level and turn it back to the wall. Similar to a combi boiler. I have just looked back through the regs this seems to have changed and it isn't mentioned now. It now mentions if at high level it should be discharged...
Replies
11
Views
287
Fitted unvented hotwater cylinder building control looking forms signed it off job was in england i am qualified northern ireland send out a form to fill in what do u need to sign off in england as building control said they dont give out forms like they do in northern ireland
Replies
4
Views
218
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
2
Views
230
P
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock