Search the forum,

Discuss How to??? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

helpsy

Plumbers Arms member
Plumber
Gas Engineer
Messages
1,754
How to connect a combi to an unvented cylinder?
 
Combi hot to kitchen sink then t off heating circuit with all the controls wired up.
 
combis are usually cheaper to buy than similar system boilers also it gives one outlet thats not reliant on the cylinder being heated ive often done it with either the kitchen or the ensuite on the combi which works for families where one works and leaves early without the need to heat the cylinder till later
the other scenario is existing combi in good condition growing family means its not enough to run 2 bathrooms add a small unvented for one and other on combi
 
Last edited:
Status
Not open for further replies.

Reply to How to??? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
0
Views
115
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
255
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
175
I have a plumber coming tomorrow to change a cartridge on a badly dripping tap on my bathroom mixer unit. There is no separate isolating valve for this tap so I'll have to close the stopcock. I tried closing it today but it won't go absolutely 100% closed and there is still a very slight flow...
Replies
1
Views
216
    • Like
  • Sticky
We have 2 brand new cordless, battery powered press tools in stock, and flying off the shelves. Our TekTools TZ1930 & TZ1550 are packed with advanced features - these cordless press tools are engineered for speed, precision, and ease of use across various applications. Just reply to this thread...
Replies
5
Views
770
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock