Search the forum,

Discuss health, safety & environment Citb card test HVACR ( heating and plumbing) in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
N

NickDavies

Hi all

50 multiple choice questions in 45 minutes to get the CITB card

Any feedback appreciated, what is the pass mark etc

Many thanks
 
Can't remember, but I do remember that the book is basically the test, memorised it and passed in 15mins
 
I passed the test this morning at a centre where you can also sit your driving theory test.

The test itself was very straight forward, 4 worksite safety scenarios with multiple choice questions and then 50 multiple choice questions, I was in and out in less than 30 minutes.

The security was a bit over the top probably because in the same room at different workstations people were sitting the driving theory test, but I had to empty my pockets, turn out my pockets and roll up my sleeves, there were cctv cameras everywhere. when I sat down at the workstation I decided to take off my jumper and hang it on the back of my chair as the room was stuffy and hot.....within 30 seconds someone was telling me it had to be put into the security locker.
 
Status
Not open for further replies.

Reply to health, safety & environment Citb card test HVACR ( heating and plumbing) in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

My son has an apprenticeship interview for to become a plumber and heating engineer. The have said there will be a multiple choice exam for this for suitability. The thing is my son panics during tests/exams. Is there any book I can buy him to practice the multiple choice test for the exam? What...
Replies
3
Views
439
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
5
Views
501
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I have changed the 3 port actuator Honeywell head however this doesn’t seem to have solved the issue, does this mean that the programmer is faulty? Or is...
Replies
8
Views
326
Hi, I have a Worcester 28i junior boiler that has started to lose pressure, only when using the central heating. When using hot water I have no issue, however, when running the heating the pressure drops. Im looking for some ideas on what could be causing this. I have no sign of pipe leaks...
Replies
6
Views
212
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
545
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock