Search the forum,

Discuss Gas Fire Manuals in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.

Viper Gas

Plumbers Arms member
Plumber
Gas Engineer
Messages
177
Hello,

had a look on here to find a gas fire section but alas it did not show itself.

I am actually after an installers manual for a valor black beauty Unigas 2 room sealed radiant convector gas fire.

thanks

DD368
 
Last edited:
would be good if we had website with all gas fires like we do with boilers, alot of hassle getting manuals for fires.
 
here's a link to valor..[DLMURL="http://www.valor.co.uk/1763.htm"]Baxi UK[/DLMURL]. give them a call, they may be able to email you a set :)
 
Last edited by a moderator:
Yes it is, thanks

it seems that there is no section for gas fires.

how comes, moderator??

DD368
 
Status
Not open for further replies.

Reply to Gas Fire Manuals in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

  • Article
A Plumber Who Worked Illegally Gets A Suspended Sentence After Falsely Claiming To Be Gas Safe Registered. A Plumber in Herefordshire was prosecuted after Hereford Trading Standards Team found that he was falsely claiming to be on the Gas Safe Register when he was not, putting members of the...
Replies
0
Views
169
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
5
Views
481
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Replies
5
Views
265
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
140
Hi All, I am looking to take my bath out and fit a shower. Regards to tanking. Is it ok to just seal everything with plastic rather than just paint tanking slurry? Thanks in anticipation, best regards Staggers
Replies
3
Views
118
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock