Which thread for KONTITE fitting please?

Post new thread

Discuss Which thread for KONTITE fitting please? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
R

RobbieT

Hello there,

I've just removed a (very dodgy) fitting which used a KONTITE nut. I want to find a blanking cap to go over the threaded pipe but don't know what thread this nut is to find a replacement.

Any help appreciated.

Thanks,
Rob

IMG_20101212_172547.jpgIMG_20101212_172607.jpgIMG_20101212_172635.jpg
 
I think a standard 3/4" bsp blanking nut will fit if I have read the measurement correctly 1.054" = od of 3/4 pipe
 
Status
Not open for further replies.

Reply to Which thread for KONTITE fitting please? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Replies
2
Views
255
Lou
Lou
M
Viessmann external flue run conundrum
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to...
Replies
9
Views
360
mutley racers
M
B
What is correct toilet supply line
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic...
Replies
2
Views
249
ShaunCorbs
ShaunCorbs
T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going...
Replies
1
Views
337
ShaunCorbs
ShaunCorbs
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new...
Replies
1
Views
298
SimonG
SimonG

Newest Plumbing Threads

Back
Top