Search the forum,

Which thread for KONTITE fitting please?

Post new thread

Discuss Which thread for KONTITE fitting please? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
R

RobbieT

Hello there,

I've just removed a (very dodgy) fitting which used a KONTITE nut. I want to find a blanking cap to go over the threaded pipe but don't know what thread this nut is to find a replacement.

Any help appreciated.

Thanks,
Rob

IMG_20101212_172547.jpgIMG_20101212_172607.jpgIMG_20101212_172635.jpg
 
I think a standard 3/4" bsp blanking nut will fit if I have read the measurement correctly 1.054" = od of 3/4 pipe
 
Status
Not open for further replies.

Reply to Which thread for KONTITE fitting please? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
153
Lou
Lou
M
Viessmann external flue run conundrum
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
221
mutley racers
M
B
What is correct toilet supply line
Hi. I need a new toilet supply line but donā€™t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
198
ShaunCorbs
ShaunCorbs
T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it šŸ˜¬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
285
ShaunCorbs
ShaunCorbs
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
216
SimonG
SimonG
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tilers Forum
Tile Blog
Electrician Talk Forum
UK Tiling Forum
Tiling Forums UK
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock