Search the forum,

sime ar4 oil boiler

Post new thread

Discuss sime ar4 oil boiler in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
J

jensda

Messages
33
good evening guys I have a couple of the above boilers to service shortly and would appreciate if anybody could point me in the right direction for manf spec all I know Is there fitted with riello 3gb burners my problem is I have tried the net with no joy and want to make sure they are set up properly with nozzles pressure etc they will be fga on completion any pointers at all would be much appreciated regards jensda
 
Status
Not open for further replies.

Reply to sime ar4 oil boiler in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

P
  • Question
Could the BAXI commercial boiler parts/flue melt ?
Boiler is SIRIUS THREE FS 70 Potterton commercial. Situation: We are small building contractors and my labourers managed to damage the radiator pipes during the strip out. Not the end of the world as damages happens. I am responsible builder and paying my bills and to repair the damages if...
Replies
1
Views
48
ShaunCorbs
ShaunCorbs
M
Viessmann external flue run conundrum
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
237
mutley racers
M
F
  • Question
No Hot water, Fixed and Broken Again Ideal Logic 24
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
161
Lou
Lou
F
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
5
Views
503
FozzieBear
F
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
215
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tilers Talk
UK Tiling Forum
DIY Forum
Tiling Advice Live
Tiling Forum
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock