Discuss Pipe layout question in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
8
Hello
Can you help I need some advice regarding the layout of some central heating pipes i have an obstacle I need to route the pipes over and just really would like to know if my plan will work without causing any problems I was going to tee off then across a bit. then up the offset will only be 50mm up then over the obstacle then back down 50mm I have attached a rough drawing of the plan any help is appreciated thanks steve

DSC_0002 (1).JPG
 
Cant see a problem with it steve. Whats the pipe going to? What size is the pipe and what type of system do you have?
 
Evening what is the obstacle you are going around and where is it and why are you doing it? I.e extra radiator?
 
On the drawing where it tee's off half way across where I want to jump over the rsj the pipes drop downstairs basically i want to move the pipes over as the walls being battened then plasterboarded over so they can be hidden I have uploaded a picture the red line is where the rsj is and the blue lines are where I want to drop the pipes thanks
_20170925_224009.JPG
 
On the drawing where it tee's off half way across where I want to jump over the rsj the pipes drop downstairs basically i want to move the pipes over as the walls being battened then plasterboarded over so they can be hidden I have uploaded a picture the red line is where the rsj is and the blue lines are where I want to drop the pipes thanksView attachment 31166
If the wall is being battened. And plasterboarded can they not be routed inside the fake wall?
 
Picture one in green is where I want to come up from under the floorboards then travel over the top of the floorboards around half a meter clearing the rsj then back out in picture two then drop back down under the floorboards then down the wall cheers
_20170925_232924.JPG
_20170925_233414.JPG
 
Picture one in green is where I want to come up from under the floorboards then travel over the top of the floorboards around half a meter clearing the rsj then back out in picture two then drop back down under the floorboards then down the wall cheersView attachment 31168 View attachment 31169
It should work. And there is already pipework ran above the floor in there anyway. Not ideal but will be ok.
 
Status
Not open for further replies.

Reply to Pipe layout question in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m...
Replies
6
Views
332
Hi, grateful for any advice I need to connect a dishwasher waste water outflow pipe 25mm to 50mm waste pipe. Is there a joining piece anyone can...
Replies
9
Views
434
Hello, I am fitting a new bathroom, and changing the layout. I've fitted one bathroom before, but I did have issues with smells occasionally, that...
Replies
3
Views
556
P
  • Question
Boiler is SIRIUS THREE FS 70 Potterton commercial. Situation: We are small building contractors and my labourers managed to damage the radiator...
Replies
2
Views
147
Hi, came across this old push fit waste pipe. Stripped out the old shower and it was a 40mm waste pipe siliconed in the fitting. The fittings at...
Replies
3
Views
585
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock