Search the forum,

Moving soil pipe 1 metre in the below floor construction

Post new thread

Discuss Moving soil pipe 1 metre in the below floor construction in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
M

mutley racers

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
5,172
Afternoon folks. I am looking to move a soil pipe connection in this sub floor: Screenshot_2017-02-23-16-50-59.jpg

Is it possible, and how do I go about making good the damp proof membrane and other bits and pieces?

Cheers
 
Status
Not open for further replies.

Reply to Moving soil pipe 1 metre in the below floor construction in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

U
Below Ground Soil Pipes on Self Build Bungalow
Just started gound work on self build bungalow and wondering best way to do below ground soil pipes. For toilet I was going to go straight down through slab and out through deadwork into a manhole. I will work out falls from manhole and set the height of the waste water system as required. For...
Replies
2
Views
113
umiq88
U
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
189
dreikher
dreikher
W
Outdoor Tap at Porch
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
234
Dave Moore
D
A
copper vs pushfit pipes
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
252
Chuck
C
127bit
How to reinforce shower pan threshold?
The left rear floor corner is highest (the shower pan touches/sits on the floor), sloping down diagonally to the front right corner (lowest). The front right corner shim is 5/8", the left front corner is 3/8" shimmed, with shorter shims under left middle and right rear corner. The pan perimeters...
Replies
5
Views
147
Timmy D
T
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Plumbing Advice
Electrical News
Tile Advice
Electrical Blog
British Standards in Tiling BS5389
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock