Search the forum,

Lease finance van

Post new thread

Discuss Lease finance van in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
R

rocketmanbkk

Plumbers Arms member
Plumber
Messages
4,113
Hi friends

What site/place is cheapest to lease finance a van/pickup then please?

Want it cheap as poss and I'm not vat registered.

Cheers

Rct
 
Nationwide is cheap but mileage allowance is carp. If your after a vw then swissvans is the best by far. I think they do other vans but they are a transporter specialist.
 
You will have to google it to find out for yourself which is cheapest.
Try newcardiscount.com
 
Last edited:
They are very good mate, they even do a non status lease that you can give them.back with a months notice
 
Northgate - national and u get unlimited miles of VW transporter for between £75 and £125 a week from memory?
 
Avoid Vanarama. I got there in the end but a load of hassle.
 
Status
Not open for further replies.

Reply to Lease finance van in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

P
LCS to new water mains
Hi, I have an old steel water mains pipe (approx 45mm) that I need to connect to a new pehd water mains (25mm). I can't get at it to create a new thread so what's the best way of connecting the two? Cheers, Peter
Replies
2
Views
222
ShaunCorbs
ShaunCorbs
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
168
Lou
Lou
D
Cistern filling one third of the way
Hi All, does anyone know why the water only fills 1/3 of the way please?
Replies
4
Views
198
dwaindigital
D
K
Running copper pipework above / across a Gas boiler?
Hi all, this is probably a daft question but I need to run my cold feed from one side of my wall mounted boiler to the other. Running it beneath the boiler is difficult with lots of obstacles, is it okay if I run soldered copper over / across the top of the boiler? It'll be about 4" off the top...
Replies
2
Views
173
kristeva
K
A
copper vs pushfit pipes
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
279
Chuck
C
Creating content since 2001. Untold Media.

Newest Plumbing Threads

TilersForums.co.uk
Tilers Forum
Electrical Blog
Plumbers Forum - Plumbing Advice
Tile News
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock