Immersion heater hot water bath

[Dan'llfixit]

Can't you just get an ultrasonic cleaner ??

I could, however I want it a bit more fancy.

What are the specialist parts ?

I was going to put glassware in it, that needs to be really clean. The plan was to have two polypropylene containers, one inside the other, so that all the gunk will flow over the top of the inside one and collect in the outside one.

Could maybe use a stainless container, that might get rid of a lot of the fire potential:

 

[SimonG]

Ultrasonic heated bath.

 

[king of pipes]

There are loads of heated ultrasonic baths on ebay bud . regards kop

 

[CHRISX]

Hi,

I am looking to build a DIY hot water bath, I was planning on using a small screw plug immersion heater, drilling a hole into a polypropylene tank and using a nut/gasket to seal it.

Recon it could work?

Hello, I can`t really contribute to this thread apart from agreeing with other Members that this `contraption` exudes DANGER !

I have found that I cannot post a new thread without getting a Forum Error Message about having too many `Tags` even though there were no Tags within the message.

I have asked Moderator Lou about this.

I have replied to this thread just to see IF I can submit a reply even though I cannot submit a new thread.

Chris

 

[Dan'llfixit]

I think I might go for an ultrasonic heater

 

[Dan'llfixit]

Shall have to see whether I can get a tank connector through the bottom however.

 

[king of pipes]

You know it makes sense rodders ha ha kop

 

[ShaunCorbs]

Good call