D
dawgas
just wondered if any damage to the flow sensor could take out the pcb on an Ideal Logic. Can anyone advise please.
- Thread starter dawgas
- Start date
- Replies 5
- Views 1K
- hot hot water ideal ideal logic logic no hot water water
Discuss Ideal logic no hot water in the Plumbing Jobs | The Job-board area at PlumbersForums.net
- Status
- Messages
- 34,367
- Solutions
- 2
why do you ask ?
if you are gas safe reg get your post count upto 10 (non spamming) and pm gas man
if you are gas safe reg get your post count upto 10 (non spamming) and pm gas man
D
dawgas
Have water damage inside the sensor, now got 240V to pcb, internal fuse intact but nothing else. No display or anything.
- Messages
- 34,367
- Solutions
- 2
are you gas safe reg if not naughty naughty as you need to be as soon as you take the case off
D
dawgas
Yes am gas safe, soon as i get to 10 will pm gasman. that's 3.
R
Rickster123
Until then im afraid this thread is closed
- Status
Reply to Ideal logic no hot water in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
- Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold...
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two...
Can anyone remember the Mira mixer shower that would work down to a really low pressure on a vented hot water system without a shower pump?
Hi,
My current hot water system needs to be replaced.
Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't...
Hi everyone,
Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I...
Newest Plumbing Threads
-
Y Plan central heating gets hot on hot water demand
- Started by MPGASANDPLUMBING
- Replies: 0
-
Grant boiler rusting inside after 1 yr
- Started by RayPlumb
- Replies: 5
-
Instructions say to apply glass cement to rubber washer. Can I use silicone?
- Started by JM Tiling
- Replies: 2
-
How do I remove the copper pipe from the plastic connector?
- Started by JM Tiling
- Replies: 2
-
Pressure reducer/regulator for plastic water line?
- Started by carpetguardian
- Replies: 1
-
Cold water issues in the top bathroom
- Started by Apex84
- Replies: 2
-