Search the forum,

Hot water cylinder jacket over thermostat?

Post new thread

Discuss Hot water cylinder jacket over thermostat? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
T

Touran Daddy

Hello all,

quick question, just fitted a jacket around my hot water cylinder and left the immersion heater uncovered, should I leave the cylinder thermostat uncovered as well or does it not make any difference?

thanks
 
Status
Not open for further replies.

Reply to Hot water cylinder jacket over thermostat? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
311
oz-plumber
O
B
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
244
oz-plumber
O
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
240
DIwhYdidIstartThis
D
T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it šŸ˜¬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
277
ShaunCorbs
ShaunCorbs
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
199
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tilers Forum
Plumbing Advice
Tilezine Tiling News Tile Association
Tiling Advice Live
Contractor Advice Forum
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock